Inside the tank are two bolts holding the tank on to the base. Unscrew these two bolts and carefully lift running toilet the tank from the base. Remove tank to the trash.
When you get to the house stand if front of the toilet and locate the water shut off valve. Should be down below the toilet on the wall. Just turn it off (righty-tighty) completely and flush the toilet. All the water should have left the tank, well at least most of it. If there is remaining water line repair get it out with paper towels or a rag. The important thing is that no more water came in. If it did then your valve is not shut all the way or not working and you need additional help.
The first thing you need to do after leakage starts is to shut the water supply before you remove the faucet. You can either shut the valve in the sink or the main valve of your home. After that ensure that the water in the water line is drained and also the air pressure s released. This will also help in saving a lot of water that might have been wasted due to the leakage.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
Check that your plug holes and waste outlets are clear of hair and solidified soap also check the "U" bends or traps under your sinks for potential blockages. Occasionally pour boiling water line repair down your sinks and shower wastes not forgetting the washing machine trap. Look outside too for any weeds or leaves that may be blocking gutters, gully's and waste outlets.
The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.
Re-coat the RV roof every two years. There are a several products for re-coating your RV's roof. Many will products recommend to re-coat every year, but it's not necessary, every two years is perfectly fine. A great affordable option is Camco RV Pro-Tec Rubber Roof Care System.